top of page

Stack and Cover Firewood Before the Wet Season Locks In

5 minutes ago
8 min read

Wet firewood is one of those problems you only notice once the stove is lit. It hisses, it smokes, it blackens the glass, and it gives you a fraction of the heat you worked for. In a Mediterranean climate the fix is all about timing. Summer does the drying for you, but only if the wood is split, stacked, and covered before the winter rains settle in for months.


Our latest firewood came the way a lot of homestead things come: through friends. A friend of ours has plenty of mimosa wood, so we went over, got the logs cut into smaller pieces, and hauled two loads on another friend's truck, roughly 4 to 5 m³ (about 140 to 175 cubic feet), and dumped it all on our land. To give it a proper home, I also built an additional storage space for firewood behind one of our containers. Here is how we went about it, plus the stacking and covering basics that keep any woodpile dry through a wet winter.


Large pile of cut Mimosa firewood logs with bark and visible end grains heaped near a metal shed structure under a clear blue sky.
Two truckloads of cut mimosa rounds sit in a heap on the pad beside the container. A pile like this holds moisture at the bottom and needs to come off the ground and under a roof before the rains.

Why Firewood Needs a Plan Before the Rains


Fresh cut wood is full of water. Before it burns well, most of that water has to leave, and it leaves mainly through the cut ends and split faces. The usual target is a moisture content of about 20% or below. Above that, a lot of the fire's energy goes into boiling water out of the wood instead of heating your room, and you get more smoke and soot.


In a summer dry climate, the hot months do most of the drying. Winter does the opposite. Rain soaks the outside of an uncovered stack, damp ground wicks moisture up into the bottom row, and wet wood that sits in still air starts to rot and grow mold. That is why the job has a deadline. You want the wood split, stacked, off the ground, and under a roof before the lasting rains arrive, so it spends the wet season protected and the next dry season drying.


A cheap moisture meter takes the guessing out of it. Split a piece and test the fresh inside face, not the weathered outside.


Tough Tip: Split before you stack, not after. Split wood dries far faster than whole rounds, and splitting later means handling the whole pile twice.


Our Mimosa Woodpile: From a Friend's Land to Ours


Mimosa is no stranger to us. We manage it on our own land, which I wrote about in our mimosa management post. So getting wood from a friend who has plenty of it made a lot of sense.


Milwaukee M18 chainsaw with a long bar placed on a timber stand in a wooded area with dry grass and scattered wood.
Our red Milwaukee chainsaw is parked on the sawhorse after a day of cutting mimosa. Most of the rounds from the two truckloads are short enough for the stove, though they still wait for a splitting axe.

Once the logs were cut into smaller pieces and the truck had dumped both loads on our land, the easy part was over. A dumped pile is not a woodpile. Wood lying in a heap on bare ground stays damp at the bottom, holds water in the middle, and does not get the airflow it needs. That is why the shelter had to be ready before the rain.


I will be honest about our own pile: not all the wood is split yet. I still need to get a splitting axe. Split before you stack is still the advice I would give anyone, and it is on my own list too. The good news is that most of our logs already fit into our wood burner, and I have already started burning some of the wood to heat the house.


Building a Firewood Shelter Behind the Container


A firewood shelter does not have to be fancy. It needs a solid frame, a roof that sheds water away from the wood, and open sides so wind can move through.


For the frame, I used the wood I had on hand: the old roof rafters from our granite stone house ruin. I tried to get the biggest footprint I could out of them. Old timber like that is perfect for a job like this, as long as it is still sound. Before you trust reclaimed wood as structure, check it for rot, soft spots, and insect damage, and cut out anything that crumbles under a screwdriver.


Wooden frame structure holding a dense stack of firewood logs against the side of a green shipping container.
Old roof rafters from the granite house ruin form the open frame behind the container, with the first rounds already stacked on pallets. The sides stay open so air can move through.

To cover it, I screwed down sandwich panels before the rain arrived, so everything stayed dry. Our panels have a foam core. That is a bit of overkill for a woodshed, but they are easier to install when you work alone. The building materials supplier had panels 4.5 m (about 14.8 ft) long and I needed 2 m (about 6.6 ft), so I asked for them to be cut to 2.25 m (about 7.4 ft), because extra roof space is always good.


Our roof slope is about 20 degrees. Because the panels are continuous and overlap on a ridge, the slope mattered less to me than it would on a tiled roof. Whatever roof you use, make sure water runs off away from the stack, let the roof overhang the wood a little on every side so blown rain does not reach it, and fix it down well, because a loose panel in a winter storm is a hazard. Foam core panels like ours can burn, so keep the shelter clear of dry vegetation and anything that throws sparks.


Roofed firewood storage with a red corrugated metal roof covering stacked logs beside green shipping containers.
The sandwich-panel roof is on, shedding water over the stacked mimosa against the container. Extra length on the panels gives a bit more covered space than the original frame.

This is not the final version. I plan to extend this space in the future and add additional vertical supports, so I can stack the firewood safer and higher in both directions. Starting small and building on it is how most of our systems grow here.


Tough Tip: Build the shelter one panel width bigger than you think you need. Wood always shows up faster than storage does.


How to Stack Firewood So It Dries


Get It Off the Ground


The bottom row is where most stacks go wrong. Lay the first row on something that keeps it clear of the soil, such as pallets, old rails or beams, or a row of stones. The goal is a gap of air under the wood so ground moisture cannot wick up into it.


Let the Air Through


Stack in single rows if you can, with a hand's width of space between rows and a gap behind the stack if it runs along a wall or a container. Air moving through the stack is what dries it. A pile packed tight against a wall stays damp on that side all winter.


Crisscross the Ends


The ends of a stack are the weak point. Build each end as a small tower, laying pieces in alternating directions, two one way and two the other. That locks the end in place and gives the rest of the row something to lean on. If you have posts or vertical supports, they do the same job and let you go higher.


Keep It a Safe Height


A freestanding stack without supports should stay at about chest height, roughly 1.2 m (4 ft). Higher than that, a stack can lean and fall, and a falling woodpile can hurt someone badly. Lean the row very slightly inward as you build, check it from the side, and restack anything that starts to bulge. Higher stacks need proper vertical supports, which is exactly why I want to add them to our shelter.


Bark Up on Top


On the top layer, lay pieces bark side up where you can. Bark sheds water a little like a roof tile, which helps if rain blows in under the cover.


Tough Tip: Stack the newest wood at the back and the driest wood at the front, so you always burn the oldest, best seasoned wood first.


Cover the Top, Leave the Sides Open


The rule is simple: roof yes, walls no. Cover only the top of the stack. If you use a tarp, let it hang down a short way over the sides, weigh it down, and leave the rest of the stack open. A tarp wrapped all the way to the ground traps moisture inside and turns your woodpile into a sauna.


Place the stack where it gets sun and wind if you can. A spot that stays shaded and still all winter dries wood slowly and grows mold. Face the open side toward the prevailing wind and the long side toward the sun.


Think about distance from the house as well. In a fire-prone landscape, a woodpile is fuel. Keep the main stack well away from your home, about 10 m (33 ft) is a common rule of thumb, and avoid stacking firewood under overhangs or against wooden walls. Our shelter sits roughly 10 to 15 m (about 33 to 49 ft) from the house, and the walk there from our main entrance door is definitely longer. Bring a small amount closer to the stove as you need it, a few days' worth at a time.


Tough Tip: Walk past your woodpile in the first real storm of the season. Ten minutes of watching where the rain blows in shows you exactly where the cover needs to go.


Final Thoughts on How to Stack and Cover Firewood


Firewood is a slow system. The work you do before the rains decides how well you heat the house a winter or more from now. Split the wood, get it off the ground, stack it with gaps and solid ends, and cover the top while leaving the sides open to sun and wind. Our mimosa came from friends, started as a heap on the ground, and now has a roof of fitted sandwich panels on a frame of old rafters. It is not finished, since the wood still needs splitting and the shelter will grow, but it is moving in the right direction, and that is how most of our projects start.


Herman's Tough Kraut Fixes: Common Challenges When You Stack and Cover Firewood


Most firewood troubleshooting comes down to water and air. Here are the questions that come up most when you stack and cover firewood before winter.


Q: How do I know when firewood is dry enough to burn?

A: Aim for about 20% moisture or below. A moisture meter on a freshly split face is the easiest check. Dry wood also feels lighter, shows cracks on the ends, and sounds hollow when two pieces knock together.


Q: Can I just wrap the whole stack in a tarp?

A: Cover the top only. A tarp wrapped to the ground traps moisture and stops airflow, so the wood stays damp and can grow mold. Let the sides breathe.


Q: My wood got rained on before I covered it. Is it ruined?

A: No. Surface rain dries off quickly once the stack is covered and air can move through it. Wood that sits wet on the ground for months is the real problem, so get it up and under a roof as soon as you can.


Q: Is it OK to stack firewood against a container or a wall?

A: Leave a gap of a hand's width or more so air can move behind the stack. Keep the main woodpile well away from your house, and do not stack against wooden walls or under overhangs.


Q: How high can I safely stack firewood?

A: Without supports, keep it to about chest height, roughly 1.2 m (4 ft), with crisscrossed ends. For anything higher, add solid vertical supports and check the stack regularly for leaning.

Comments


  • Youtube
  • Facebook
  • Instagram
  • X
  • Pinterest

 

© 2026 - ToughKraut.com

 

bottom of page